Loading...
7x17x5 Front Rubber Avid RC Ball Bearing

7x17x5 Front Rubber Avid RC Ball Bearing

CODE: 697-2RSF


Price: 7.00

(Including tax)
Out-of-stock, Can be delivered on request
350 points

Product details page tabs

7x17x5 Front Rubber Avid RC Ball Bearing.

The Avid 7x17x5 Engine Bearing offers the amazing performance and reliability to your Traxxas engine at an unbeatable price. The bearing specs are Abec3, 8 Chrome Steel 52100 Balls, Chrome Steel 52100 Balls Cage, and Chrome Steel 52100 Rings.

If your engine is not listed below, please check with your manufacturer first to see what size you require.

Engines Used In

  • Traxxas: 2.5, 2.5R, 3.3
  • Picco: .26 MAX, .26 Max JL Red Dot
  • RB: TM323

Tips

  • Diagnosing: Typically you can tell a front bearing is going out if after a run there is a large wet spot on the bottom of your motor next to the flywheel. A little bit of wet is ok and usually just a sign of a rich low-end needle. If the bearing is bad your risks/issues will be inconsistant tune and possible chance of damaging the crank/case if it complete goes.
  • Installation: The best way to install is to use a bearing puller/installer, OFNA makes a very affordable one. If you place the new bearing in the freezer for 15 minutes it will be easier to install.
  • Positioning: This is a double rubber sealed bearing. It is recommended for proper lubrication to remove one of the seals and place the rubber seal towards the outside (facing clutch).