Зареждане...

HPI Bullet Flux ST/MT Aluminium Alloy Front C-hub and Knuckle Arms Set with ball bearings (Purple)

КОД: BU2088ALUFR


Цена: 49.99

(с ДДС)
Няма наличност, Може да бъде доставен по заявка
2500 т.

Product details page tabs

One of the weakest spots on your bullets are the front axle mounts and the front C-hubs (mostly the axle mounts that HPI offers as Upright set). Now we offer to you these aluminum alloy mounts in one complete kit, featuring Revolutions ball bearings for supreme low friction. It is meant for use with the HPI 101270 CVD shaft set, but you can try it using the regular shafts and dogbones - you will need a couple of 5x8mm shims to do that.

Please note - you will need a set of screws that currently we do not offer (as the manufacturer explained - they are imperial thread, we could only supply metric) to attach the C-hubs to the upper and lower arms. You will also need the original lower arm hinges (101302 - 3*25mm Front Outer Suspension Shaft), spacers (101305 - Wheel Spacer Set), wheel hexes and/or CVD kit that we offer separately. Kit should be used with HPI 101270, but feel free to experiment with regular HPI 101228 5x40mm axles and drive shafts. You should add some bearing oil and/or grease to the bearings and threadlock to all screws. If you experience any wheel locks after you attached the tire, please check the C-hub screws length (they should be shortened as we test them prior to shipping, but still).

Kit includes:

  • Aluminium Front left and right C-hubs
  • Aluminium Front left and right Axle holder
  • 4x 10x15x4mm Ball Bearings
  • 2x 5x10x4mm Ball Bearings (mount in the 10x15 bearing)
  • 2x 5x11x4mm Ball Bearings (mount on knuckle outer side)
  • 2x 12x15x0.02mm Shims
  • 4x C-hub screws with spacers